The 101 Association, Inc.
For the preservation and enjoyment of 1928 to 1931 Indian Scout Motocycles
"You can't wear out an Indian Scout"
 
Forgot password

metric fasteners on an export engine?

  • 05 Dec 2016 9:25 AM
    Quote
    Message # 4440049
    Harry Roberts

    My motor, EG766, came from Sweden via Norway, and as I'm beginning to remove the heads I find the head bolts are not 1/2" or 9/16", but somewhere in between.  A 14mm is close but still a little sloppy in my opinion.  Would the fasteners on a motor built for export have metric fasteners?  Maybe Whitworth?
  • 06 Dec 2016 1:50 AM
    Quote
    Reply # 4441669 on 4440049
    Deleted user

    The threads must have been altered by some mechanic or perhaps distorted by overtorquing or rust. In my opinion there was no reason for the Indian company to change threads for any export bikes. 
  • 07 Dec 2016 9:36 AM
    Quote
    Reply # 4444694 on 4440049
    Deleted user

    My EGP 1154 is from Norway has US threads. The only metric threads I have found on it are yoke spring retaining nuts on the Mesinger No.3  half-pan saddle and they looked to be original. regards geir.
  • 12 Dec 2016 5:22 PM
    Quote
    Reply # 4455809 on 4440049
    Harry Roberts

    Thank-you for the replies.  I was referring to the bolt heads and not the threads, sorry if I wasn't clear!  These head bolt threads are 7/16 -20,  but the bolt heads are too large to take a 1/2" wrench and too small for a 9/16" wrench and I've never seen a 17/32" wrench... so I used a 14mm with success but it triggered my question!

    Last modified: 12 Dec 2016 5:30 PM | Harry Roberts
 AMCA Chapter WebRing AMCA National 
Next >>       Random       Hub       << Prev
 
Classic Motorcycle Webring

Classic Motorcycle Webring
Join Now | Ring Hub | Random | << Prev | Next >>

Indian Motorcycles Webring
 
<< Prev | Hub | Rate | Next >>

Copyright © 2009 The 101 Association, Inc. All rights reserved. 

Powered by Wild Apricot Membership Software